HONDA HARMONY II HRS216PDA - Manual (Page 12)

Flywheel Brake Lever
This lever is connected to the
engine flywheel brake and the
ignition switch. The engine will not
start unless this lever is pulled
backward.
Drive Clutch Lever (SD)
The drive clutch lever engages
(push forward) and disengages
(release) the transmission that
drives the rear wheels. The drive
clutch lever should only be
engaged after the engine has
been started.
Cutting Height Adjustment Levers
There are six approximate settings [1 ~ 3-1/2 in. (25 ~ 87 mm)]. The
adjusters move back to lower and forward to raise the mower deck.
For the best overall lawn finish, each wheel should be adjusted to the
same position.
CONTROLS
10
FLYWHEEL BRAKE LEVER
DRIVE CLUTCH LEVER (SD)
1" (25 mm)
1-1/2 " (37 mm)
2" (50 mm)
2-1/2" (66 mm)
3" (75 mm)
3-1/2 (87 mm)
REAR ADJUSTMENT LEVER
FRONT
ADJUSTMENT
LEVER
RIGHT SIDE SHOWN