Storage, Engine, Other – Husqvarna 62522FE User Manual

Page 14

Advertising
background image

14

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS

FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS

CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING

STORAGE. ALCOHOL BLENDED FUELS (CALLED GASOHOL OR

USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE

WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS

DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL

SYSTEM OF AN ENGINE WHILE IN STORAGE.

• Empty the fuel tank by starting the engine and letting

it run until the fuel lines and carburetor are empty.

• Never use engine or carburetor cleaner products in

the fuel tank or permanent damage may occur.

• Use fresh fuel next season.
NOTE: Fuel stabilizer is an acceptable alternative in mini-

mizing the formation of fuel gum deposits during stor age.

Add stabilizer to gasoline in fuel tank or storage container.

Always follow the mix ratio found on stabilizer container.

Run engine at least 10 minutes after adding stabilizer to

allow the stabilizer to reach the carburetor. Do not empty

the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en-

gine oil. (See “ENGINE” in the Maintenance section of

this manual).

CYLINDER

1. Remove spark plug.
2. Pour one ounce (29 ml) of oil through spark plug hole

into cylinder.

3. Pull starter handle slowly a few times to distribute

oil.

4. Replace with new spark plug.

BATTERY

Disconnect the battery from the engine connector and

charge battery 48 hours.

OTHER

• Do not store gasoline from one season to another.
• Replace your gasoline can if your can starts to rust. Rust

and/or dirt in your gasoline will cause problems.

• If possible, store your unit indoors and cover it to give

protection from dust and dirt.

• Cover your unit with a suitable protective cover that

does not retain moisture. Do not use plastic. Plastic

cannot breathe, which allows condensation to form

and will cause your unit to rust.

IMPORTANT: NEVER COVER MOWER WHILE ENGINE AND

EXHAUST AREAS ARE STILL WARM.

CAUTION: Never store the lawn mower

with gasoline in the tank inside a build-

ing where fumes may reach an open

flame or spark. Allow the engine to cool

before storing in any enclosure.

STORAGE

FIG. 18

LOWER HANDLE

SQUEEZE

TO ADJUST

FIG. 19

MOWING

POSITION

OPERATOR

PRES ENCE

CONTROL

BAR

FOLD

FORWARD

FOR

STORAGE

LOWER

HANDLE

HANDLE

KNOB

UPPER

HANDLE

HANDLE (See Figs. 18 and 19)

You can fold your lawn mower handle for storage.
1. Squeeze the bottom ends of the lower handle toward

each other until the lower handle clears the handle

bracket, then move handle forward.

2. Loosen upper handle mounting bolts enough to allow

upper handle to be folded back.

IMPORTANT: WHEN FOLDING THE HANDLE FOR STORAGE

OR TRANSPORTATION, BE SURE TO FOLD THE HANDLE AS

SHOWN OR YOU MAY DAMAGE THE CONTROL CABLES.

• When setting up your handle from the storage position,

the lower han dle will automatically lock into mow ing

position.

Advertising
This manual is related to the following products: