HP 7200 - Manual (Page 140)

3. Connect the other end of the Ethernet cable to an available port on your Ethernet
router, switch, or wireless access point.
4. Once you have connected the HP All-in-One to the network, go to your computer
to install the software. See
Install the software for a network connection .
Install the software for a network connection
Use this section to install your HP All-in-One software on either a Windows or
Macintosh computer connected to an Ethernet network. However, before you install
the software, make sure you have connected your HP All-in-One to an Ethernet
network as described in the previous section,
Connect to an Ethernet network .
Note If your computer is configured to connect to a series of network drives,
make sure that your computer is currently connected to these drives before
installing the software. Otherwise, HP All-in-One installation software might
take one of the reserved drive letters, and you will not be able to access that
network drive on your computer.
See the instructions below for your Windows or Macintosh computer.
For Windows
The following instructions are for Windows computers only.
Note Installation time can range from 20 to 45 minutes depending on your
operating system, the amount of available space, and the processor speed of
your computer.
To install your HP All-in-One software
1.
Quit all applications running on your computer, including the internal XP firewall
and any other firewall or virus detection software.
User Guide 137
Set
up
your netw
ork