HP 3C339 User Manual
Page 21
4 Connecting to a Windows NT Server 4.0
Windows 95 SR2
Windows 95 SR2
Requirements
•
HP Vectra VE7/VE8with Windows 95 SR2.
•
3COM TokenRing 3C 339 card and drivers disk
•
Windows 95 media.
•
Microsoft Windows NT Server 4.0 machine that supports Net BEUI, TCP/
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
•
I/O Base Address
DC00
•
Interrupt Request Level
10
•
Boot PROM
Disabled
•
Transceiver Type
Auto Select
•
Network Driver Optimization
Windows or OS/2 Client
•
Maximum Modem Speed
9600 Baud
•
Plug and Play Compatibility
Disabled
•
Full Duplex
Disabled
Procedure
1
With the HP Vectra VE7/VE8 turned off, install the 3COM Token Ring
3C339 adapter card into an PCI slot.
2
Connect network cable media to the 3COM 3C339 card.
3
Insert a DOS bootable diskette and power on the machine.
4
After booting, insert the 3COM drivers disk “Etherlink 3C339 Drivers.”
and change to Drive A: , and execute “3C3X9CFG.EXE.”
5
Select “Configure NIC,” and verify the resource settings listed above
under the heading “Device Configuration.”
6
If changes are required, save those changes and exit.
7
Remove the 3Com Software driver diskette and reboot the machine.
8
Click on “Start” and point to “Settings”, then select the “Control Panel.”
9
In the Control Panel group, double click on the “Network” icon .