Philips HR6835 - Manual (Page 10)

tri-scopic tube (specific types only)
1 Adjust the tube to the length you find most comfortable during vacuum cleaning. Press one
of the two collars downwards and pull the tube part above the collar upwards or push it
downwards (Fig. 5)
nozzle
1 Connect the nozzle to the tube. (Fig. 6)
 If you want the nozzle close at hand (e.g. to clean stairs, upholstery or tapestries), connect
the nozzle directly to the handgrip. (Fig. 7)
Prepare the vacuum cleaner for either dry or wet use.
Note:When you unpack the appliance, it is ready for wet use.
Preparing for dry use
Always remove the float unit and the diffuser and insert the Micro Filter (specific types only) and
the paper or reusable dustbag before you vacuum dry substances.
1 Make sure the appliance is unplugged.
 Turn the shampoo hose clockwise (1) and pull it out of the motor unit (2). (Fig. 8)
 Remove the shampoo reservoir (Fig. 9)
 Undo the clamps. (Fig. 10)
5 Lift the motor unit from the container by the handle. (Fig. 11)
6 Turn the motor unit upside down. (Fig. 12)
7 Remove the diffuser from the motor unit. (Fig. 13)
8 Remove the float unit from the container. (Fig. 14)
9 Insert a paper dustbag or the reusable dustbag. Press and hold the red lever while you place
the front of the dustbag into the holder. (Fig. 15)
10 First insert the bottom edge (1). Then press the top edge into place (2). (Fig. 16)
Make sure that the two projections of the front point downwards and that the centre of the
bottom edge rests on the ridge of the holder.
11 Slide the holder with dustbag into the appliance in such a way that the holder is kept in place
by the two ridges in the container. (Fig. 17)
1 Put the motor unit back onto the appliance and close the clamps (‘click’). (Fig. 18)
1 Put the Micro Filter into place (specific types only). (Fig. 19)
See chapter ‘Replacement’ for replacing the paper dustbag or chapter ‘Cleaning’ for emptying
the reusable dustbag.
Preparing for wet use
Always remove the paper or reusable dustbag and the Micro Filter (specific types only) before wet
use.
Preparing for vacuuming liquids
To vacuum liquids, you need the float unit and the diffuser.
1 Make sure the appliance is unplugged.
 Undo the clamps. (Fig. 10)
 Lift the motor unit from the container by the handle. (Fig. 11)
,
English 10