Honeywell TE322ELW User Manual

Page 5

background image






Main unit: 2 AA size (UM-3) 1.5V batteries (not included)

Remote Sensor: 2 AAA size 1.5V batteries (not included)


Main unit: 3.5(L) x 7.09(H) x 1.18(D) inches

Remote sensor: 2.35(L) x 3.77(H) x 0.86(D) inches


This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2)

This device must accept any interference received, including

interference that may cause undesired operation.

Warning: Changes or modification to this unit not expressly

approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

NOTE: This equipment had been tested and found to comply

with the limits for a Class B Digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference

in a residential installation. This equipment, installed and

used in accordance with the instructions, may cause harmful

interference to radio communications.

There is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to improve or correct turning the interference

by one or more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver.

• Connect the equipment to an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio / TV technician

for help.


Check here before contacting customer service.


When the time alarm sounds, press the SNOOZE/LIGHT

button to temporarily stop it. After the SNOOZE/LIGHT

is depressed, the time alarm sound will resume in four minutes.

If the alarm is not disabled after that, it will sound for two

more minutes and then will stop by itself.

The backlight feature is enabled only after the time is set.

To activate the backlight press the SNOOZE/LIGHT button

once, and both – clock and weather station displays - will

light up for five seconds.


This product is engineered to give you years of satisfactory

service if handled carefully. Here are a few precautions:

• Do not immerse the units in water.

• Do not clean the units with abrasive or corrosive materials.

They may scratch the plastic parts and corrode the electronic


• Do not subject the product to excessive force, shock, dust,

temperature, or humidity, which may result in malfunctions,

shorter lifespan, damaged batteries, and damaged parts.

• Do not tamper with the units internal components. Doing

so will invalidate the warranty and may cause damage.

These units contain no user-serviceable parts.

• Use only fresh batteries. Do not mix new and old batteries.

• Read the user's manual thoroughly before operating the





Main unit

Remote sensor

US Atomic Time

signal is not received

Cannot locate remote


Cannot change the


Cannot change the ºC

to ºF and back

Data does not match

data on the main unit

Place unit by the

window and keep it

there overnight

Check batteries

Check location

Press and hold DOWN

( ) button on the main

unit to search for the

signal form the remote


Press "RESET" after

setting the channel

Press "RESET" after

setting ºC/ºF

Initiate manual sensor

search (Press and hold

DOWN ( ) button on

the main unit)


Main Unit

Indoor Temperature

Proposed operating range

: 23.0°F to 122.0°F

(-5°C to +50°C)

Temperature resolution

: 0.2°F (0.1°C)

User-selectable (°F or °C) temperature display

Weather Forecast in five large graphic icons: Sunny, Partly

Cloudy, Cloudy, Rainy and Snowy

Maximum number of remote sensors

: 3 (one included)

Readings update interval

: every 45 seconds

EL backlight

Low battery indicators – for each remote channel and main unit


Precise atomic time

4 US Time Zones

12/24 hour time format

Crescendo 4 minutes alarm with 5 minutes snooze

Remote Sensor

Remote Temperature

Proposed operating range with alkaline


: -4°F to + 158°F

(-20°C to + 70°C)

Proposed operating range with lithium


: -38.8°F to +158°F

(-38.8°C to + 70°C)

Temperature resolution

: 0.1°C/0.2°F

RF Transmission Frequency

: 433 MHz

RF range

: Maximum 328

feet (100 meters)

Temperature transmission cycle

: approximately

45 seconds

Low battery indicator

Wall-mount of Table stand