Husqvarna 346XP 351 - Manual (Page 35)

English –
35
TECHNICAL DATA
Bar and chain combinations
The following combinations are CE approved.
Bar Chain
Length, Pitch, Max.
inches inches tip radius
13 0,325 10T Husqvarna H30
15 0,325 10T Husqvarna H30
16 0,325 10T Husqvarna H30
18 0,325 10T Husqvarna H30
13 0,325 10T Husqvarna H25
15 0,325 10T Husqvarna H25
16 0,325 10T Husqvarna H25
18 0,325 10T Husqvarna H25
20 0,325 12T Husqvarna H25
Type Inch Inch/mm Inch/mm Degree Degree Degree Inch/mm Inch/cm: dl
H30 0,325" 0,050"/1,3 3/16" /4,8 85° 30° 10° 0,025"/0,65 13"/33:56 15"/38:64
16"/40:66 18"/45:72
H25 0,325" 0,058"/1,5 3/16" /4,8 85° 30° 10° 0,025"/0,65 13"/33:56 15"/38:64
16"/40:66 18"/45:72
20"/50:78
1
5
L
EC-declaration of conformity
(Applies to Europe only)
Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declares under sole responsibility that the chain saws
Husqvarna 346XP, 351, 346XP E-tech and 351 E-tech from 2002's serial numbers and onwards (the year is clearly stated in
plain text on the type plate with subsequent serial number), are in conformity with the requirements of the COUNCIL'S
DIRECTIVES:
- of June 22, 1998 ”relating to machinery” 98/37/EC, annex IIA.
- of May 3, 1989 ”relating to electromagnetic compatibility” 89/336/EEC, and applicable supplements.
- of May 8, 2000 ”relating to the noise emissions in the environment” 2000/14/EC.
For information relating to noise emissions, see the chapter Technical data.
The following standards have been applied: EN292-2, CISPR 12:1997, EN608.
Notified body: 0404, SMP Svensk Maskinprovning AB, Fyrisborgsgatan 3, 754 50 Uppsala, Sweden, has carried out EC type
examination in accordance with the machinery directive's (98/37/EC) article 8, point 2c. The certificates for EC type examination
in accordance with annex VI, have the numbers: 404/98/578 - 346XP, 404/98/573 - 351, 404/00/743 – 346XP E-tech,
404/00/744 – 351 E-tech.
In addition, SMP, Svensk Maskinprovning AB, Fyrisborgsgatan 3, 754 50 Uppsala, Sweden, has certified conformity with
annex V of the Council's Directive of May 8, 2000 ”relating to the noise emissions in the environment” 2000/14/EC. The
certificates have the numbers: 01/161/002 - 346XP, 01/161/004 - 351, 01/161/003 - 346XP E-tech, 01/161/004 - 351 E-tech.
The supplied chain saw conforms to the example that underwent EC type examination.
Huskvarna January 3, 2002
Bo Andréasson, Development manager