HP 1100A - Manual (Page 72)

72 Chapter 8 Troubleshooting the printer EN
Manual feed
The printer is in manual feed
mode.
Check that you have loaded the correct
paper, then press and release the Go button
on the printer control panel to print. Manual
feed is controlled by the software. If you do
not want to be in manual feed mode, change
the setting from your printer properties. See
“
Printer properties (driver) .”
Door open, no toner cartridge,
or paper jam
The printer is in an error state.
Check the following:
● The printer door is closed.
● The toner cartridge is correctly installed
in the printer. See “
Changing the toner
cartridge .”
● There are no paper jams. See “ Clearing
printer paper jams .”
Paper out
The printer is out of paper.
Load paper into the printer. See “ Loading
paper into the printer .”
Memory out
The printer ran out of memory in
the middle of a print job.
The page being printed may have been too
complex for the memory capacity of the
printer.
● See “ Memory (DIMMs) ” to add
memory.
● Press and release the Go button to print.
Reset/Printer initialization
The printer memory is being
reset and all previously sent
print jobs are being purged. Or,
a printer initialization is taking
place. All lights blink for 1/2 of a
second or longer if initializing.
No action is necessary. However, you can
reset the printer if you press and hold the Go
button for 5 seconds.
Control panel light messages (continued)
Light status Condition of the printer Action