Connect the hp photosmart to the network – HP D7200 User Manual
Page 8
has a different connector. An Ethernet cable connector (also called an RJ-45
connector) is wider and thicker and always has 8 contacts on the end. A phone
connector has between 2 and 6 contacts.
❑ A desktop computer or laptop with an Ethernet connection.
NOTE:
The HP Photosmart supports both 10 Mbps and 100 Mbps Ethernet
networks. If you are purchasing, or have purchased, a network interface card
(NIC), make sure it can operate at either speed.
Connect the HP Photosmart to the network
To connect the HP Photosmart to the network, use the Ethernet port on the back of the
device.
To connect the HP Photosmart to the network
1.
Remove the yellow plug from the back of the HP Photosmart.
2.
Connect the Ethernet cable to the Ethernet port on the back of the HP Photosmart.
3.
Connect the other end of the Ethernet cable to an available port on your Ethernet
router, switch, or wireless router.
Chapter 2
6
Network setup
N
etwork set
up