Honeywell TE22W - Manual (Page 6)

10 9
MAXIMUM AND MINIMUM READINGS
The maximum and minimum record of the indoor and remote
temperatures will be automatically stored in the memory of
the main unit (receiver).
To display the minimum, maximum or the current reading
press MEM button.
If no button is pressed for the next 15 seconds, the unit will
return to the current temperature display.
To clear the memory, press and hold MEM button for two
seconds and all previously stored readings will be erased.
TEMPERATURE TRENDS
The temperature trend indicators located on the indoor and
remote temperature information lines show the trend of
temperatures collected indoors and at particular remote sight.
There are three trends that can be displayed: Rising, Steady,
and Falling.
TRANSMISSION COLLISION
Signals from the other household devices such as wireless
doorbells, home security systems, and entry control, may
interfere with this product or cause temporary reception
interruption. This is normal and will not affect the general
performance of the product. The transmission and reception
of the temperature readings will resume once the interference
subsides.
ATOMIC CLOCK
After the main unit receives information from the remote
sensor, the atomic time signal receiver will start to search
for the time signal. It usually takes between 5-8 minutes.
Once the atomic time signal is received, the date and time
will be set automatically, and the [ ] icon will appear under
the US Time Zone Map icon.
If the time signal has not been received in 8 minutes, press
MODE button to set the time and date manually.
After the unit is set manually, place it by the window for the
better reception. The unit’s atomic clock receiver is
programmed that it will continue to search for the atomic
time signal daily for every hour between 1:00 am and 4:30 am.
Once the time signal has been successfully received, the time
and date will be updated automatically.
CALENDAR AND CLOCK DISPLAY MODES
Date is displayed in month-date format. Each press of the
MODE button will change the clock display setting between
the time of day with seconds and time of day with the day
of the week.
4. Fresh batteries are installed correctly in both remote sensor
and main unit.
If there is no reception, please perform the following steps:
1. Bring the main unit and remote sensor close together.
2. Remove four (4) small screws from the back of the remote
sensor with small Phillips screwdriver, and open the
battery compartment.
3. Remove the batteries from the battery compartment and
reinstall them in the same manner. Remote sensor LED
indicator will flash showing transmission of the signal.
4. Remove the batteries from the main unit and reinstall them
in the same manner.
5. The remote temperature appeared on the main unit’s display
will show that transmission is being received successfully.
LOST COMMUNICATION
If the main unit display line for the remote sensor reading
goes blank, press and hold DOWN ( ) button for 2 seconds
to begin a new signal search. If the signal still isn’t received,
please make sure that:
1. The remote sensor is in its proper location.
2. The distance between main unit and remote sensor is not
over 100 feet (30meters).
3. The path between units is clear of obstacles. Shorten the
distance if necessary.
• Make sure the main unit is positioned at 8 feet (2 meters)
distance from any interference source such as a TV, computer
monitor, microwave, etc.
• Within concrete wall rooms such as basements or office
buildings, the received signal may be weakened. Always
place the unit near the window for better reception.