Homelite UT43122 - Manual (Page 22)

Page 22 — English
Fig. 31
BAR GROOVE
CHAIN DRIVE LINKS
Fig. 29
CUTTERS CHAIN ROTATION
CHAIN DRIVE LINKS
Fig. 28
Fig. 30
CAUTION:
Always wear gloves when handling the bar and
chain; these components are sharp and may
contain burrs.
WARNING:
Never touch or adjust the chain while the motor
is running. The saw chain is very sharp; always
wear protective gloves when performing main-
tenance to the chain to avoid possible serious
lacerations.
BAR STUDS
CHAIN TENSIONING
PIN HOLE
CHAIN TENSIONING
KNOB
MAINTENANCE
NOTE: When replacing the guide bar and chain,
always use the specified bar and chain listed in
the
Bar and Chain Combinations section later
in this manual.

Disconnect chain saw from power supply.
 Rotate the chain cover lock knob counterclock-
wise and remove knob.
 Remove the chain cover.
CHAIN COVER
LOCK KNOB