Husqvarna 966957301 - Manual (Page 8)

8
WARNING: When pulling starter rope, the rope
can unexpectedly jerk back toward engine causing
serious injury. To avoid this risk, carefully follow these
instructions:
Move rocker switch to "I" position.
5. Grasp starter cord handle. Se Fig. 9
a. Pull rope out slowly until you feel drag.
b. Without allowing the rope to retract, continue
pulling rope with one rapid full arm stroke.
c. Return rope slowly to original position.
Note:
Following the instructions listed in the steps above avoids
potential damage to the recoil mechanism.
6. If engine fails to start after 3 attempts repeat steps 2
thru 5 and try again.
7. When engine starts:
a. Momentarily move choke lever to "1/2 CHOKE"
position until engine runs smoothly.
b. Next, move choke lever to "NO CHOKE" position.
Note:
If engine starts but falters when choke in moved to "NO
CHOKE" position:
a. Momentarily move choke lever to "FULL
CHOKE" position.
b. Next, move choke lever to "NO CHOKE" until
engine runs smoothly.
c. Finally, move control to "NO CHOKE" position.
If engine dies after choke is moved to "NO CHOKE"
position, repeat steps 2 thru 7 to restart engine.
8. If engine fires but does not continue to run, move
choke control lever to "NO CHOKE" position.
• Push yellow compression relief valve in.
• Pull starter rope again.
9. If engine fails to start after 3 attempts move choke
control to "FULL CHOKE" position.
• Push yellow compression relief valve in.
• Pull starter rope again.
10. If engine does not start after following steps 1 thru 9,
contact your Authorized Tecumseh Servicing Dealer.
DO NOT attempt to start or troubleshoot this engine
in any other way.
Fig. 9 Starter Cord Handle Location
Fig. 10 Choke Lever Position
2
3
1
Full Choke
1/2 Choke
No Choke
1.
2.
3.
After the engine is started and has run for a few seconds,
move the choke lever as far as it will go in the opposite
direction from the starting position.
Tilt the unit back onto the drag stake to raise the tines off
the ground.
With the tines still off the ground, squeeze and release the
throttle trigger a few times. If the tines do not stop rotating
when trigger is released, adjust carburetor idle speed as
instructed in Adjustment/Maintenance section.
To shut off the engine, release the throttle control lever
and move the On/Off Switch to the “O” position.
OPERATING TECHNIQUE AND HANDY TIPS
1. Start engine and tilt unit back until tines are off the
ground. Squeeze throttle lever to full speed position
(lever tight against grip). Remember, this unit is
equipped with a governed engine and must always
be run at full speed position.
2. Lower front of unit until tines begin to dig into ground
to start filling.
3. Unit will tend to walk forward at this point and must
be firmly held back to allow tines to till.
4. If adjustments to tilling depth must be made,
proceed as follows:
a. Shut engine off by moving switch to “O” position.
b. Remove hairpin cotter and clevis pin from drag
stake and adjust upward if unit is tilling too
deeply. Adjust stake downward if more depth is
necessary.
c. Move switch to “I” position and restart engine to
continue tilling.
DRAG
STAKE
Fig. 11