Hitachi SA200 - Manual (Page 105)

B Using the BIOS Setup Program
SA200 93
The default value for this field is: 2F8
The Interrupt options are:
•
IRQ 3
•
IRQ 4
•
IRQ 10
•
IRQ 11
The default value for this field is: IRQ 3
Parallel Port
These options allow you to enable the parallel port and configure
its Operation Mode, Base I/O Address and Interrupt setting. If you
don’t plan to use the parallel port, you can set it to “Disabled” to
conserve power.
The Parallel Port options are:
•
Enabled
•
Disabled
The default value for this field is: Enabled
The Operation Mode options are:
•
Output only
•
Bi-directional
•
ECP
Check your parallel device’s documentation to see which mode it
can use. Most devices use Standard or Bi-Directional mode.
The default value for this field is: ECP
The Base I/O Address options are:
•
378
•
278
•
3BC
The default value for this field is: 378
lonestar.boo : sa200.fm Page 93 Friday, March 6, 1998 10:53 AM