Maintenance, Warning – Homelite CSP3816 User Manual
Page 36
UK - Page 36
CLEANING THE SPARK ARRESTING
SILENCER
The silencer is equipped with a spark arrester screen. A
faulty spark arrester screen may create a fire hazard.
Through normal use the screen becomes dirty and should
be inspected weekly and cleaned as required. Always keep
the silencer and spark arrester on your saw in good
condition.
WARNING
Silencer surfaces are very hot during and after
operation of the chainsaw. Keep all body parts away
from the silencer. Serious burns may occur if contact is
made with the silencer.
1.
Allow the silencer to cool.
2.
The spark arrester screen is retained by the deflector.
Remove the nuts and screen retainer to access the
spark arrester screen.
3.
Replace the spark arrester screen if it is cracked or
otherwise deteriorated.
CHAIN BRAKE
Q
Q
Q
Q
Q
Remove the clutch cover and clean the chain brake
components. Check wear on the brake band. If brake
band is worn or deformed, have it serviced at your
nearest authorised service centre.
The band thickness
should not be less than 0.60 mm (0.025 in.) or worn
halfway through.
Q
Q
Q
Q
Q
Always keep the chain brake mechanism clean and
lightly lubricate the linkage.
Q
Q
Q
Q
Q
Always test the chain brake performance after servicing
or cleaning. Refer to “Operation - Operating Chain Brake”
earlier in this manual for additional information.
Q
Q
Q
Q
Q
Check and, if damaged, replace the chain catcher.
STORING THE CHAINSAW (1 MONTH OR
LONGER)
1.
Drain all fuel from tank into a container approved for
petrol.
2.
Run the engine until it stops. This will remove all fuel-oil
mix which could become stale and leave varnish and
gum in the fuel system.
3.
Drain all bar and chain oil from tank into a container
approved for oil.
4.
Clean all foreign material from the saw.
5.
Store it in a well-ventilated place inaccessible to
children.
NOTE:
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
Abide by all regulations for the safe storage and handling of
petrol. Excess fuel should be used up in other 2-cycle
engine powered equipment.
BRAKE BAND
CLEAN THE CHAIN BRAKE
LUBRICATE THE CHAIN
BRAKE LINKAGE
SILENCER
SPARK ARRESTER
SCREEN
Fig. 79
Fig. 80
CHAIN CATCHER
Fig. 81
NUTS
MAINTENANCE