Heath Zenith Instant Motion Sensor Light Control SL-5211 - Manual (Page 3)

3 595-4238-07
TEST AND ADJUSTMENT
❒
Turn on the circuit breaker and light switch.
SPECIFICATIONS
Range . . . . . . . . . . . . Up to 60 feet (varies with surrounding
temperature).
Sensing Angle . . . . . . Up to 110 °
Electrical Load . . . . . . 25 to 75 watt Incandescent
Power Requirements
(Lamps off) . . . . . . . . 120 VAC, 60 Hz
Operating Modes . . . . TEST, AUTO and MANUAL OVER-
RIDE
Time Delay . . . . . . . . 1 , 5, 10 minutes
Sensitivity . . . . . . . . . Adjustable
HeathCo LLC reserves the right to discontinue products and to
change specifications at any time without incurring any obliga-
tion to incorporate new features in products previously sold.
The detector is less sensitive to motion directly towards it and
more sensitive to across motion.
Aim Sensor Down
for Short Coverage
❒ Walk through the coverage area
noting where you are when the
lights turn on. Move the sensor
head up, down, or sideways to
change the coverage area.
❒
Adjust the SENSITIVITY as
needed. Too much sensitivity
may increase false triggering.
❒ Set the amount of TIME you want
the lights to stay on after motion
is detected (1, 5, or 10 minutes).
Least Sensitive Most Sensitive
Sensor
Motion
Motion
Avoid aiming the control at:
• Objects that change temperature rapidly, such as heating
vents and air conditioners. These heat sources could
cause false triggering.
• Areas where pets or traffic may trigger the control.
• Nearby large, light-colored objects reflecting day may trig-
ger the shut-off feature. Do not point other lights at the sensor.
Bottom of Sensor
60 ft.
5 ft.
Maximum Range Maximum
Coverage Angle
110 °
NOTE: Sensor has a 1 1 /
2
minute warm up period before it
will detect motion. When first turned on or when
switching modes wait 1
1 /
2
minutes.
❒ Turn the SENSITIVITY (SENS) control to the mid position
and the ON-TIME control to the TEST position.
ON-TIME
10 5 1 TEST MIN MAX
SENS
Aim Sensor Higher
for Long Coverage