High End Systems AF1000 - Manual (Page 23)

Chapter 2 Mini Controller Operation 2-5
2
Intensity
The < intensity > key changes the brightness of the AF1000 strobes. There are
three sets of Intensity parameters: Incremental, Program Functions, and
Function Advance.
Incremental
There are 64 Incremental Intensity parameters. These parameters are annotated on
the display by
1 through 6 4 , with 1 being the dimmest and 6 4 being the
brightest.
Program Function
Following the Incremental parameters, there are seven Program Function
parameters. Refer to Table 2.2 and the Addendum for the effect of each Program
Function.
Function Advance
The last Intensity parameter is Function Advance. Function Advance is annotated
by
F A on the display. When this parameter is selected, a Program Function ( F 1 –
F 7 ) is used at random and an Intensity of 6 4 is used fifty percent of the time.
Table 2.2: Intensity Program Functions
Program
Function
Manipulation of Intensity
F 1 Ramp down
F 2 Ramp up
F 3 Ramp up and down
F 4 Random–changes every time a
program is run
F 5 Maximum Intensity for one run of
the program, then minimum
Intensity for the next run of a
program
F 6 Maximum Intensity for two steps,
then minimum Intensity for the
next two steps
F 7 Maximum Intensity for one step,
then minimum Intensity for one
step