Connection to the rgb signal terminal, Connection to the video signal terminals, 20 1. input / output signal – Hitachi CP-S840W/E User Manual
Page 20: Signal input / output terminal, Input signal, Signal input terminal
20
1. Input / output signal
Connection to the RGB signal terminal
2. Signal input / output terminal
5
1
10
6
15
11
D-sub 15pin shrink terminal
(Female)
1. Input signal
Connection to the video signal terminals
2. Signal input terminal
Ground
Luminance signal
S VIDEO input (Mini DIN4 pin)
Ground
Chrominance signal
Caution
Video input signal terminals have priority in the following order.
S-VIDEO input terminal
RCA jack input terminal
Even when the video signal is displayed, only an audio signal is output to RGB audio output terminals.
2
1
Caution
Do not use RGB cable other than that specified.
Some RGB cable may not operate DDC (Display Data Channel)
because there are not connect from pin NO.
to pin NO.
.
12
15
S-VIDEO signal
Luminance signal
1.0Vp-p, 75
W
termination
Chrominance signal 0.286Vp-p (burst signal), 75
W
termination
VIDEO signal
1.0Vp-p, 75
W
termination
AUDIO signal
Input
200mVrms, 20k
W
below (MAX 3.0Vp-p)
Output
0~200mVrms, 1k
W
Video signal
Analog 0.7Vp-p 75
W
termination (Positive polarity)
Horizontal sync signal
TTL level (Positive/negative polarity)
Vertical sync signal
TTL level (Positive/negative polarity)
Composite sync signal
TTL level
Audio signal
Input
200mVrms, 20k
W
below (MAX 3.0Vp-p)
Output
0~200mVrms, 1k
W
1
Video signal (Red)
2
Video signal (Green)
3
Video signal (Blue)
4
N.C
5
N.C
6
Ground (for R)
7
Ground (for G)
8
Ground (for B)
9
N.C
10
Ground
11
N.C
12
DDC (Display Data channel) RGB1 only
13
Horizontal/Composite sync signal
14
Vertical sync signal
15
DDC (Display Data channel) RGB1 only