Hasbro Transformers Optimus Prime 27653 - Manual (Page 2)

P/N 7076200000
TO REPLACE BATTERIES:
Use a Phillips/cross head screwdriver (not included) to
loosen screw in battery compartment door (screw remains
attached to door). Remove door and discard old batteries.
Insert 2 x 1.5V fresh “AA” or R6 size batteries. Alkaline
batteries recommended. Replace door and tighten screw.
IMPORTANT:
BATTERY INFORMATION
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified
and be sure to insert them correctly by matching the + and – polarity
markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with
alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference,
move it away from other electrical equipment. Reset (switching off and
back on again or removing and re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of
batteries. Always remove from the product before recharging. Recharge
batteries under adult supervision. DO NOT RECHARGE OTHER TYPES
OF BATTERIES.
R
e
v
e
r
s
e
o
r
d
e
r
o
f
in
s
tr
u
c
ti
o
n
s
to
c
o
n
v
e
r
t
b
a
c
k
i
n
to
r
o
b
o
t.
17
20
24
21
26 25
18 19
23 22
27
VEHICLE MODE VEHICLE MODE
Push down to reveal
moving armor panels
and internal gears!
Push buttons to snap
out Power Hooks! Push button for Engine Revving
and Truck Racing Sounds!
button
button
button
SIDE VIEW TOP VIEW
SLOT
CAB PIECE
SLOT
NOTE: Fit cab pieces into
slots on arms.
© 2010 DreamWorks LLC and Paramount Pictures Corporation
© 2010 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
Manufactured under license from Tomy Company, Ltd.
NEED HELP?
TRANSFORMERS.COM/INSTRUCTIONS
Retain instructions for
future reference.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Product and colors may vary.
Some poses may require hand support.