Husqvarna 5021 R - Manual (Page 23)

MAINTENANCE
23 1741506
HOW TO REPLACE THE AUGER
1. Remove the belt cover. See “How To Remove
The Belt Cover.”
2. Remove the drive belt. See “How To Replace
The Drive Belt.”
3. (Figure 11) Remove the auger pulley (1) from
the auger shaft (threads are left hand; turn clock-
wise to remove).
4. To keep the auger (2) from rotating, set a
2” x 4” piece of wood (3) on the center pad-
dle (4) to secure the auger (2).
5. Remove the fasteners from the bearing as-
sembly (4). Remove the bearing assembly
(4) from the auger housing (5).
6. Slide the auger (2) out the bearing assem-
bly on the right side of the snow thrower.
7. Tip the auger (2) enough to allow the auger
(2) to slide out of the auger housing (6).
8. To install auger (2), reverse the above steps.
1
5
4
3
2
6
HOW TO ADJUST THE BRAKE PAD
IMPORTANT: An adjustment is only necessary if
the brake pad has become loose or has been re-
moved. to adjust, proceed as follows:
1. Remove the top cover. See “How To Remove
The Top Cover.”
2. Remove the belt cover. See “How To Remove
The Belt Cover.”
3. Tie the auger drive lever to the handle. This will
engage the drive system.
4. (Figure 12) Loosen the screw and nut that
secure the brake pad arm (1).
5. Set the clearance between the brake pad (2)
and the drive belt (3) to 1/8 inch (3 mm).
6. Tighten the screw and nut that secure the brake
pad arm (1).
7. Connect the wire to the spark plug.
1
2 3
Figure 11
Figure 12