Harman Stove Company P35I - Manual (Page 20)

20
P35i Fireplace Insert
Pellets or Corn/Pellet Mixture Only Save These Instructions 3-90-775R15_04/13
Most importantly, the frame must be level. Again, be
certain that the surround is not supporting the weight.
Turn the leveling screws in until there is a slight gap
beneath the surround panels.
Here are a few different ways to anchor the mounting
frame.
On the sides of the frame,
there are a few holes which
can be used to attach
metal straps. These straps
can be anchored into the
fireplace using masonry
anchors. You could also
use any of the unused
holes in the bottom of the
frame to install anchors
and lag bolts. Another
option involves using kit #
1-00-774279. Here, you will mount plates to the frame.
These plates have coupling nuts welded to them. The
kit also includes two pieces of 1/2" all thread, which
threads into the coupling nuts. These can be used to
tighten upward against the lintel until the unit is secure.
E. Attaching the Venting
The flue collar on the rear of the mounting frame is
designed to pivot. Loosen the four mounting bolts and
adjust the angle of the collar as needed. Shown above
is the vertical position and the horizontal position. Be
sure the fiber gasket remains in place between the
collar and the mounting frame, and secure the bolts.
Secure the first section of venting to the collar with
a minimum of two fasteners. Self-drilling screws will
work well for this. Once the venting is secured and the
seams are sealed, it is recommended that you wrap
the vent pipe with a non-combustible insulation to
prevent overheating of the motors and other appliance
components. This is required (and supplied) when
using the optional Zero Clearance Cabinet.
The mounting frame is the anchor for the appliance.
If the frame is not secured properly, shifting will
occur when sliding the insert in or out.
D. Securing the Mounting Frame
The mounting frame is the anchor for the appliance.
If the frame is not secured properly, shifting will
occur when sliding the insert in or out.
The stove is supplied with a Leg Leveler Kit that
contains (4) 5/16-18 X 1". These bolts should be
threaded down through the holes to raise the frame
corners as needed, to level.
NOTE: When installed in a rear vent configuration, the maximum BTU
may be reduced due to elevated ESP temperatures associated with the
horizontal exhaust stream.
Straps could
attach here
Leveler Bolts