Hearth and Home Technologies GFK21B - Manual (Page 2)

Hearth & Home Technologies • GFK21B Fan Kit • 4016-096 Rev I • 11/08 2
• If the fan is being installed in a B-vent appliance, the fan
shield supplied with the appliance will also need to be
attached. See Figure 3.
1. Install the Fan Bracket & Shield
• Place the fan bracket around the fan. See Figure 1.
• Use pliers to crimp the bracket tabs around the fan
housing. See Figure 2.
• If no fan shield is needed, install screws to hold the front
of the fan bracket in place. See Figure 4.
Figure 2 Crimp Bracket Tabs
Figure 3 Fan Shield
Figure 6 Magnets
Figure 1 Fan Bracket-No screws
Figure 4 Fan Bracket
Figure 5 Foam Tape
• Attach the foam tape (Figure 5) and magnets (Figure 6)
to the fan. Cut one magnet strip in half and save the
remaining strip for control module.