Operating instructions, Maintenance and servicing – Harbor Freight Tools 66514 User Manual
Page 5
SKU 66514
for technical questions, please call 1-800-444-3353.
Page 5
operating inStructionS
read the entire important
Safety information section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
After reading these instructions,
1.
consider the following points before
starting the pump:
Verify that the pump rests on the
a.
floor of the fountain.
Verify that the electrical connection
b.
is 120 V~, 60 Hz.
Verify that the electrical receptacle is
c.
in good condition.
Verify that water and moisture can-
d.
not get near the power supply recep-
tacle.
Verify that the pump is installed so
e.
as to prevent running dry.
To prevent tripping, run any extension
2.
cord used away from walkways that
lead to your location.
Place the Fountain Pump on a sur-
4.
face slightly elevated (to prevent col-
lection of excessive mud), and open
either or both switches located on the
Tee Fitting System (10) by rotating
them towards the + symbol.
Plug the Fountain Pump into the
5.
power outlet. The Fountain Pump will
begin operating automatically.
When not using the Fountain Pump
6.
for a long period of time, unplug the
power cord, remove it from the water,
rinse with cold, clean, water and let it
dry before storing it inside away from
children.
maintenance and
SerVicing
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
to preVent
SeriouS injury
from accidental
operation or electric
SHock:
unplug the fountain pump
from its electrical outlet
before performing any
accessory change, inspection,
maintenance, and/or cleaning
procedures.
to preVent SeriouS
injury from tool
failure:
do not use damaged
equipment. if abnormal noise
or vibration occurs, have the
problem corrected before
further use.
cleaning, maintenance, and
lubrication
Before eacH uSe,
1.
inspect the
general condition of the Fountain
Pump. Check for loose screws, mis-
alignment or binding of moving parts,
cracked or broken parts, damaged
electrical wiring, and any other condi-
tion that may affect its safe operation.
after uSe,
2.
clean external surfaces
of the appliance with clean, moist
cloth.