Harbor Freight Tools BIG TOP 92942 - Manual (Page 3)

Page 3 For technical questions, please call 1-800-444-3353. SKU 92942
do not overreach. Keep proper c.
footing and balance at all times.
This enables better control of the
assembly tools in unexpected
situations.
dress properly. do not wear
d.
loose clothing or jewelry. Keep
your hair, clothing and gloves
away from moving parts. Loose
clothes, jewelry or long hair can
be caught in moving parts during
assembly.
Specific Safety Warnings
Do not attempt to assemble 1.
Canopy when high wind conditions
exist as personal injury and/or
damage to the Canopy may result.
Verify that Canopy is assembled
2.
and firmly secured (using T-stakes
provided) on a flat, level surface to
avoid accidents.
Do not allow snow to accumulate
3.
on the Canopy; the Canopy could
collapse.
caution!
4. Heavy, wet snow or
extreme windy conditions could
damage the Car Canopy. It is
recommended that the Tarp be
removed under these conditions to
prevent damage to the Car Canopy.
Maintain Canopy with care. Keep the
5.
Canopy clean, dry and free of oil,
grease, liquids and other debris.
Maintain labels and nameplates on
6.
Canopy. These carry important safety
information. If unreadable or missing,
contact Harbor Freight Tools for a
replacement.
Do not use Canopy for any purpose
7.
other than for what it was intended.
Do not use Canopy as a source of
long-term shelter.
The warnings, precautions, and 8.
instructions discussed in this
instruction manual cannot cover all
possible conditions and situations that
may occur. It must be understood
by the operator that common sense
and caution are factors which cannot
be built into this product, but must be
supplied by the operator.
SpeciFicationS
Base
Dimensions
20’ 8-1/2” L x 20’ 6” W
Center Height 10’
Side Height 69-1/4”
Frame Width 18’ 1”
Pole Tubing
Diameter
1-1/4”
Connector
Diameter
1-1/2”
Tarp
14 x 14 mesh, 1000 denier nylon
thread
unpacKing
When unpacking, make sure that
the item is intact and undamaged. If any
parts are missing or broken, please call
Harbor Freight Tools at 1-800-444-3353 as
soon as possible.
caution! Be alert to possible
wind damage; prolonged exposure to
wind can cause fasteners and hardware
to loosen as the frame flexes. The
Car Canopy’s frame strength will be
compromised if fasteners and hardware
are not tight. Periodically check and make
sure all fasteners and hardware are tight.
Tubes, stakes, tie downs and rope should
also be periodically checked to make sure
the unit is always structurally rigid.