HHB comm DRM85 - Manual (Page 10)

03:14:35
En.9
ENGLISH
The FlashMic is switched on by a SHORT PRESS on the jogswitch, and switched off by a
LONG PRESS until the text
OFF appears in the display. The FlashMic will turn off when the
jogswitch is released.
Note that it is not possible to turn the FlashMic off while it is connected to a computer via
its USB cable.
On switching the FlashMic on, the LCD panel displays in sequence:
DRM85
ê
Firmware version
ê
Microphone name
ê
Active preset.
Note that the factory default microphone name is DRM_85 and the factory default preset
is PSET_.
After this sequence, the FlashMic is in its standby state – referred to in this manual as IDLE
mode - and the displays are as shown below.
In IDLE mode – i.e. when the FlashMic is powered but not otherwise being operated – the
main display alternates between the number of the last recording (
TRKnnn - recorded files
within the FlashMic are referred to as ‘tracks’) and the remaining recording time.
An exception to this is when no recordings have been made since the FlashMic was last
reconfigured, when the message
NOFILE appears instead of TRKnnn .
The FlashMic is fitted with an internal calendar/clock. Before using the FlashMic for the
first time it is recommended that this is set correctly, as this information is included in the
audio file header as their time/date. See Clock Set Menu, page  for details of how to
do this.
Switching The FlashMic On
FlashMic IDLE Mode Displays