Husqvarna 96045001700 - Manual (Page 5)

5
UNASSEMBLED PARTS
Your new tractor has been assembled at the factory with ex-
ception of those parts left unassembled for shipping purposes.
ASSEMBLY
Fig. 1
LABEL
TO CHECK BATTERY (See Fig. 1)
• Lift hood to raised position.
NOTE: If this battery is put into service after month and
year indicated on label (label is located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in Maintenance section of this manual
for charging instructions).
• For battery and battery cable installation see "RE-
PLACING BATTERY" in the "Service and Adjustments"
section in this manual.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Stan dard
wrench sizes are listed.
(2) 7/16" wrenches
Utility knife
(1) 1/2" wrench Tire pressure gauge
(1) 3/4" wrench Pliers
(1) 3/4" socket w/drive ratchet
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton .
• Cut along dotted lines on all four panels of carton.
Remove end panels and lay side panels flat.
• Remove mower and packing materials.
• Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRACTOR FROM
SKID
(2) Keys
Slope Sheet
Keys
Mower
(1) Wheel
(5) Large Retainer
Springs - 7/16
(2) Smaller Retainer
Springs - 5/16
(1) Locknut
3/8-16
(1) Oil Drain Tube
For Future Use
(1) Shoulder Bolt
Mower Front Wheel
(1) Anti-Sway Bar
(1) 3/4 O.D. Washers
(1) 1-1/4 O.D. Washer
(3) 1-3/16 O.D. Washers
(2) Rear Lift Link
Assemblies