Hasbro Fun Shakin 06034 - Manual (Page 3)

TO INSTALL BATTERIES
Using a Phillips/cross head
screwdriver, loosen screw in
battery cover (screw will remain
attached to cover). Remove and
discard old batteries. Insert 3 x
1.5V "AA"/LR6 alkaline batteries
into battery compartment.
Replace cover and
retighten screw.
CAUTION:
TO AVOID BATTERY LEAKAGE
1) Be sure to insert the batteries correctly and always follow the toy
and battery manufacturers' instructions;
2) Do not mix old and new batteries or alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries;
3) Always remove weak or dead batteries from the product.
IMPORTANT:
BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and
be sure to insert them correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with
alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference,
move it away from other electrical equipment. Reset (switching off and
back on again or removing and re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of
battery. Always remove from the product before recharging. Recharge
batteries under adult supervision. DO NOT RECHARGE OTHER TYPES
OF BATTERIES.