Hitachi UltraVision Digital 50VX500 - Manual (Page 73)

73
LAMP REPLACEMENT
6. Without installing the lamp cover, the power will be off and the Lamp Indicator will flash (see page 8). Be sure to install the lamp
cover by re-engaging the two clips and tighten the screws before turning the power on, otherwise it may cause unusual colors.
SCREW
LAMP COVER
PHILLIP HEAD
SCREW DRIVER
NOTE: IF POWER IS CONNECTED BEFORE THE LAMP COVER IS INSTALLED, THE POWER WILL
BE OFF AND THE LAMP INDICATOR WILL FLASH (SEE PAGE 8 ).
7. Install the front cover as shown below. Put the front cover back in and align the snap on quick connect then push inwards hold-
ing the left and right side of the front cover until you hear a snap. Push the other snap on gently to make a good fit.
FRONT COVER
PUSH
PUSH
8. Plug power cord into AC outlet and turn on the main power switch.
120V
PUSH
POWER
NOTE: The lamp in this product contains Mercury. Dispose of properly in accordance with applicable environmental
laws. For Recycling and Disposal information, contact your respective governmental agencies or the
Electronic Industries Alliance at www.eiae.org (in the U.S.) or Electronic Product Stewardship Canada at
www.epsc.ca (in Canada).
LAMP
REPLACEMENT