Fuel gauge/hour meter, Headlight control, Electric bed lift – Husqvarna HUV 5420 DX User Manual

Page 18: Roll-over protective structure and seat belts, Caution, Warning

Advertising
background image

Roll-Over Protective Structure and Seat Belts

CAUTION

• Failure to add oil immediately when the low oil warning light stays on may result in permanent

engine damage.

FUEL GAUGE/HOUR METER

The fuel gauge and hour meter (8) are housed together on the right side of the instrument panel (Figure 7). The fuel
gauge operates when the key switch is in the ON position and allows the operator to monitor the fuel level in the vehicle.
The hour meter operates only when the engine is running, and should be used by the trained technician to track vehicle
usage and determine when periodic service procedures are required. See Periodic Service Schedule on page 30.

HEADLIGHT CONTROL

The headlight control (12) is located on the left side of the instrument panel (Figure 7). Press the headlight rocker
switch to turn the headlight on or off. See following NOTE.

NOTE: Using the headlights for extended periods while the engine is either off or idling will discharge the battery.

ELECTRIC BED LIFT

Vehicles with Electric Bed Lift Option

The electric bed lift switch (13) is located on the instrument panel to the left of the key switch (Figure 7). See
following NOTE.

NOTE: Remove cargo before raising the bed.

To lift the bed, push up and hold the rocker switch in the upper position. Release the switch to stop the lifting operation.
To close the bed, press down and hold the switch in the lower position. The bed lift will make a loud clicking sound to
signal that the bed is in the rest position.

HIGH-TEMPERATURE WARNING LIGHT (DIESEL VEHICLES ONLY)

The high-temperature warning light (10) is located on the instrument panel to the left of the steering column, next
to the low oil warning light (9) (Figure 7). The diesel engine is liquid-cooled; if the engine coolant has exceeded its
normal safe operating temperature, the warning light will illuminate. If the warning light comes on, stop the vehicle and
allow it to idle for approximately five minutes before stopping the engine. Contact a Husqvarna dealer/distributor or a
trained technician. See following WARNING.

WARNING

• Allow the engine to cool before servicing the engine coolant system. Engine coolant can cause

severe burns.

ROLL-OVER PROTECTIVE STRUCTURE AND SEAT BELTS

The Husqvarna HUV 5420 DX vehicles are equipped with a Roll-Over Protective Structure (ROPS) and seat belts for
each occupant. See following WARNING.

Page 16

HUV 5420 DX All-Wheel Drive CE Mark Diesel Vehicle Owner’s Manual

Advertising