Hitachi VT-F382A - Manual (Page 14)

Getting Started
14
Plug in the TV and VCR power cords to the wall outlet or an appropriate
extension cord or surge protector. See Important Safeguards for further
precautions (page 6).
6 Install Batteries in the Remote Control
The remote control requires two fresh "AA" batteries. On the back of the
remote, a plastic cover slides off in the direction shown by the arrow.
Remove this cover and install the batteries, matching the plus end of each
battery with the plus mark on the remote.
7 Set the RF or Video Channel Switch
When the VCR is on, its video signal can come into your TV on either
channel 3 or channel 4. You need to select the appropriate channel.
Turn the power on to both the TV and the VCR, and look for a switch on
the back of the VCR. Set the switch to 3 or 4, whichever is not a
commercial channel in your area.
Your basic hookup is now complete. When you're ready to try hooking up
a second VCR or a video camera for a complete home entertainment
system, see Advanced Operations.
Now turn the TV and VCR back around facing you and begin your quick
tour of the controls (page 15).