Hitachi DZ-MV780A - Manual (Page 112)

English
112
1
DIVIDING MOVIES (EDIT – DIVIDE)
You can divide a scene into two parts.
To delete unnecessary portion of scene, first divide the scene, and then delete the unnecessary
portion.
1
Press the DISC NAVIGATION button.
2
Select the scene to be divided.
3
Press the MENU button.
4
Choose, “Scene”,
“Edit”, “Divide” and
then press the A
button.
5
The “Divide Scene”
screen will appear: If
you are sure you want to divide the selected
scene, press the A button: The selected
scene will be played back.
If you want to change the scene to be divided,
you can change it on this screen.
6
When you reach the
point where you want
to divide the scene,
press the SELECT
button.
7
The screen for verifying
division will appear:
Choose “YES”, and then
press the A button.
Choose “NO” to cancel
division.
After division, the “Divide Scene” screen will
be restored.
Repeat steps 5 – 7 to divide another scene.
8
Press the C button to quit.
Note :
• If you press the MENU button before pressing the
A button in step 5, the submenu will appear (see
page 111).
• Search and frame advance are useful when
designating division points.
• Combining scenes that were divided will restore the
original scene (see page 113).
• If a special effect has been added to the original
scene, the “IN” effect will be added to the first half of
scene, and the “OUT” effect, to the latter half.
• The division point may drift before or after the
designated point by approximately 0.5 seconds.
• Since a scene with a skip set cannot be played back,
no division point can be specified: Release the skip
for the scene before dividing it.
• If the division point is at a still, a message will appear,
but no division will be made.
• If the division point is at the start or end of a scene, a
message will appear, but no division will be made.
• A movie scene whose recording time is 0.5 seconds
or less cannot be divided.
• If free space available on disc is insufficient, division
will not be possible: Delete unnecessary scenes.
S c e n e
RAM ENTER RETURN
Ed i t
E f f ec t
De v i de
De l e t e
Comb i n e
Copy
Se l e c t
De t a i l
ETC
Se l e c t D i v i s i o n Po i n t
RAM 002 0 : 00 : 18
ENTER CANCEL SEL
The status bar of
scene being played
back can be switched
off or on by pressing
the DISPLAY button
ENTER
D i v i de s c e n e?
D i v i de Sc e n e
YES NO