Husqvarna 968999515 - Manual (Page 7)

7
ASSEMBLY
1 2
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY
(See Figure 2)
NOTE: For ease of assembly, you may wish to
obtain the assistance of another person for
mounting cover assembly to mower.
1. Position cover assembly on ground behind
mower as shown.
2. Lift and rotate cover to align cover brackets
with support assembly tubes.
3. Slide cover assembly down onto the support
tubes.
FIGURE 2
COVER
ASSEMBLY
SUPPORT
ASSEMBLY
BAGGER SUPPORT ASSEMBLY
(See Figures 1A and 1B)
1. Remove rear engine guard (if installed) by
removing the six bolts that attach the guard to
the frame.
2. Place hitch Part No. 539113090 on the rear of
the mower.
3. Install two (2) previously removed bolts
(539107475) thru rear of the hitch weldment.
4. Secure the sides of the hitch to the frame
with four (4) bolts (539107899) and four (4)
washers (539990598) two per each side.
FIGURE 1A
FIGURE 1B
ENGINE
GUARD
BOLTS
REAR ENGINE GUARD
ENGINE
GUARD
BOLTS
ENGINE
GUARD
BOLTS
PREVIOULY REMOVED
HARDWARE
HITCH
WASHER, 1/4
BOLT, 5/16-18 X 3/4, GR8