haier HWM70-928NZP - Manual (Page 17)

17
Disposal after washing
After using, please clean the lint and foreign materials of the lint filter etc. in time. ●
Otherwise it may influence your using the machine.
Please first pull off the power plug from the receptacle before cleaning.
●
Clean the detergent box and set it on the control panel seat.
The lint filter must be used during ●
washing.
It must be cleaned in time after
●
each using.
1. The method of dismantle: Push it up aslant and
gently.
2. The method of install : install it upwards and
aslant and push it in .
Lint filter:
1. Push down the spring piece of the top
lint filter to make the claws out of the filter
cover, and then pull out the lint filter to get
it down. (figure1)
2. Pull the back of the lint filter, and then you
can get down it off the front cover of the
lint filter. (figure2)
3. Sweep the rubbish in the lint filter.
4. Put the back of the lint filter into the front
cover.
5. Put the lint filter into filter cover, and make
it tight.
6. Make sure the lint filter well installed, or it
can influence your use.
The filter screen of the water inlet valve is likely to be
blocked by foreign materials and influence the water inlet.
Please clean it with brush every two months.
If the cabinet is dirty, wipe it with wet cloth
Do not flush it directly with water. ●
Wipe it with neutral detergent. ●
Do not wipe it with thinner, petrol, alcohol etc. ●
1. After washing, close the water faucet. (If needed, you can dismantle the water inlet
hose).
2. Do not store water in the washing machine for a long period. Drain the water
completely after each using.
3. Be sure to pull off the power plug before maintenance.
4. Hang up the power cord and drain hose.
5. Wipe off the water drops on the surface of the machine and inside the tub. Open the
top lid for some time (about 1 hour), then close the top lid.
Dismantle Install
Install
Install
Down
Down
Dismantle
Back cover
of lint filter
Front cover
of lint filter
Dismantle
Up
Up
Figure 1 Figure 2
Thinner Petrol
Alcohol