Harbor Freight Tools 66399 - Manual (Page 5)

Page 5 For technical questions, please call 1-800-444-3353. SKU 66399
Vibration Precautions
This tool vibrates during use. Repeated
or long-term exposure to vibration may cause
temporary or permanent physical injury, par-
ticularly to the hands, arms and shoulders. To
reduce the risk of vibration-related injury:
Anyone using vibrating tools regularly
or for an extended period should first
be examined by a doctor and then have
regular medical check-ups to ensure
medical problems are not being caused
or worsened from use. Pregnant women
or people who have impaired blood cir-
culation to the hand, past hand injuries,
nervous system disorders, diabetes, or
Raynaud’s Disease should not use this
tool. If you feel any symptoms related
to vibration (such as tingling, numbness,
and white or blue fingers), seek medical
advice as soon as possible.
SAVE THESE
INSTRUCTIONS.
SPECIFICATIONS
Maximum Air Pressure 115 PSI
Speed
Fills Car Tire in Approx.
3 Minutes
Air Flow
1.3 SCFM @ 40 PSI
0.9 SCFM @ 90 PSI
Rated Air Pressure 0-115
Maximum Power 12VDC, 30 AMPS
Permanently Lubricated Do not add oil or any
other lubricant
INITIAL TOOL SET UP/
ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
Note: For additional information regarding the
parts listed in the following pages, refer
to the Assembly Diagram near the end of
this manual.
Unpacking
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown throughout
the manual as soon as possible.
• This air tool may be shipped with a
protective plug covering the air inlet.
Remove this plug before set up.
Note: Air flow, and therefore tool perfor-
mance, can be hindered by undersized
air supply components.
1. The air hose must be long enough to
reach the work area with enough extra
length to allow free movement while
working.
2. Turn the tool’s On/Off switch to the “OFF”
position; refer to Operation section for
description of controls.
3. Inspect the air connections for leaks.
Repair any leaks found.