HONDA CD Changer User Manual
Page 2
2 of 10
AII 23268 (0110)
© 2001 American Honda Motor Co., Inc - All Rights Reserved.
TOOLS AND SUPPLIES REQUIRED
#2 Phillips screwdriver
Flat-tip screwdriver
Stubby Phillips screwdriver
10 mm Combination wrench
Ratchet
10 mm Socket
Diagonal cutters
Utility knife
Tape measure
Gloves
BUS CORD
BOLTS
CD CHANGER
(sold separately)
GLOVE BOX
Illustration of the CD Changer Installed on the
Vehicle
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures should
not be attempted by “do-it-yourselfers.”
1.
Write down the frequencies for the radio station
preset buttons.
2.
Disconnect the negative cable from the battery.
3.
Remove the two bolts that fasten the glove box,
and remove the glove box.
4.
Remove the center lower cover by removing the
two screws, releasing the 11 clips, and
disconnecting the connector.
CENTER
LOWER
COVER
SELF-TAPPING
SCREW
CLIP
SCREW
CONNECTOR