Pre-delivery service, After the first 8 hours, Ser vice journal – Husqvarna 175 AWD User Manual
Page 3: Pre-deliver y service, After the fi rst 8 hours
English
–
3
Ser
vice journal
Pre-deliver
y service
1
Top up battery with acid and charge for four hours.
2
Fit steering wheel, seat and any optional equipment.
3
Adjust cutting unit:
Adjust lift springs (effective weight of cutting unit should be 12-15kg / 26.5-33 lb).
Adjust cutting unit so that rear edge is about 2-4 mm / 1/8” higher than front edge.
Adjust cutting unit height setting so that cutting height limit is 5 mm / 3/16” above the frame of the unit at the lowest
cutting height.
4
Check that the right amount of oil is in the engine.
5
Check that there is oil in the transmission’s oil tank.
6
Check and adjust tyre pressure (60 Kpa, 0.6 bar).
7
Connect battery.
8
Fill with fuel and start engine.
9
Check that machine does not move in neutral.
10 Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Lif lever safety switch.
The safety switch for the hydrostat pedals.
11 Check engine speed, 2900
±
100 rpm.
12 Tell customer about:
Needs and benefits of following the service schedule.
Servicing and the influence of this journal on the second-hand value of the machine.
Range of applications for BioClip.
Complete proof of sale etc.
Pre-delivery service carried out. No outstanding problems. Certified:
Date, mileage, stamp, signature
After the fi
rst 8 hours
1
Change engine oil