Maintenance schedule, Maintenance – Husqvarna 175 AWD User Manual
Page 22
22 –
English
Maintenance
Maintenance schedule
The following is a list of the maintenance which should be conducted on the machine. For those points not described in this manual,
visit an authorised service workshop.
1)
First change after 5 hours. When operating with a heavy load or at high ambient temperatures, replace every 50 hours.
2)
Maintenance and replacement are required
more often in dusty conditions. First change after 8 hours.
3)
If the machine is used daily it should be lubricated twice a week.
4)
Replace the oil filter every 200 hours.
5)
Replace the paper filter annually or every 200 hours.
6)
Conducted by authorised service workshop.
7)
Only 175 AWD first change after 8 hours
X = Described in this operator's manual
O = Not described in this operator's manual
Maintenance
Daily maintenance
before starting
At least
once a year
Maintenance
interval in hours
25
50
100
200
Cleaning
X
Check the engine’s oil level
X
Check the engine’s cooling air intake
X
Check the fuel pump air filter
X
Check the steering wires
X
Check the battery
X
Check the safety system
X
Check nuts and screws
O
Check for fuel and oil leakage
O
Clean around the silencer
O
Clean the prefilter in the air filter
2)
X
Change engine oil
1)
X
3
X
3
Check the cutting deck
X
Check the air pressure in the tyres, 60 kPa/8.5 PSI.
X
Lubricate the belt adjuster
3)
X
Lubricate joints and shafts
3)
X
Adjust the brake
X
Check the V-belts
O
Check the cooling fins on the hydrostatic transmission
O
Checking the transmission oil level
X
Checking and adjusting the choke wire
X
Tighten the nuts and screws
O
Checking and adjusting of throttle wire
X
Clean the cooling fins on the engine and hydrostatic transmission
2)
O
Replace the air filter’s prefilter and paper filter
2, 5)
X
X
Replace the fuel filter
X
Replace the spark plug.
X
Check the engine valve clearance
6)
Check the need to change the oil
6,7)
in the gearbox/hydraulic system
O
O
Change the oil filter
X
!
WARNING! No service procedures must be conducted on the
engine or cutting unit unless:
The engine is switched off.
The parking brake is applied.
The ignition key is removed.
The cutting unit is disengaged.
The ignition cables are removed from the plugs.