Husqvarna 175 AWD - Manual (Page 28)

28 – English
Maintenance
Main fuse
The main fuse is placed in a detachable holder under the
battery case’s cover, in front of the battery.
Type: Flat pin, 15 A.
Do not use any other type of fuse when replacing.
A blown fuse is indicated by a burnt connector. Pull the fuse
from the holder when replacing.
The fuse is there to protect the electrical system. If it blows
again shortly after replacement, it is due to a short circuit,
which must be fixed before the machine can be put into
operation again.
Checking the tyre pressure
The tyre pressure should be 60 kPa (0.6 kp/cm
2
/8.5 PSI) all
round. To improve driving the pressure on the rear tyres can
be reduced to 40 kPa (0.4 kp/cm
2 /5.6 PSI). The maximum
tyre pressure is 100 kPa (1,0 kp/cm
2
/14 PSI).
Checking the engine’s cooling air
intake
Clean the air intake grille in the engine cover behind the
driver’s seat.
Open the engine cover.
Check that the cooling intake is free from leaves, grass and
dirt.
Check the air duct, located on the inside of the engine cover,
ensure it is clean and does not rub against the cooling air
intake.
A blocked cooling intake will interfere with the cooling of the
engine, which can damage the engine.
Fitting the cutting head
1 Place the Rider on a flat surface and apply the parking
brake. Check that the lever for setting the cutting height is
in the lowest position.
Make sure the support wheels are fitted to the cutting unit
(1).
2 Grasp the handle at the front or hold the frame of the
cutting unit (2) and slide the unit underneath the rider
mower.
Make sure that the tongue (3) on the cutting unit engages
correctly.
IMPORTANT INFORMATION
Different tyre pressures on the front tyres will result in the
blades cutting the grass at different heights.
!
WARNING! The cooling air intake rotates
when the engine is running. Mind your
fingers.
!
WARNING! Wear protective glasses when
fitting the cutting unit. The spring which
tensions up the belt may break and cause
personal injury.
1
2
3