Harmar Mobility AL003 - Manual (Page 3)

Hitch Adapter Installation
REMOVE,
FLIP,
RE-ATTACH REMOVE,
FLIP, MOVE UP,
RE-ATTACH REMOVE,
MOVE UP,
RE-ATTACH
Bumper Mount
( Be sure to comply with
vehicle's bumper rating )
CLASS 1
( Flat Bar Style )
CLASS 2
( 1.25 x 1.25 Solid Bar )
Omit stabilizer
CLASS 3
( 2 x 2 TUBE )
Do not attempt to
mount up from under
Refer to diagram below
for proper orientation
( right side up or upside down )
Determines carrier's height
from the ground
DETERMINE BEST MOUNTING HEIGHT
45 max
Harmar recommends maintaining 8-12" of ground
clearance from the bottom of the unfolded platform,
while not exceeding 45 degrees of tilt ( 12" off the ground )
To achieve this, a number of mounting options are available.
8-12"
Measure from Hitch Bar to ground
AS SHIPPED
8-12"
10-14"
12-16"
14-18"
IF FLIPPING HITCH ADAPTER FOR BETTER HEIGHT,
BOTH PARTS MUST BE FLIPPED TOGETHER.
ORIENTATION OF THESE PARTS IS IMPORTANT
FOR THE TILT AWAY FEATURE LIMITS.
OR
NOTE:
ORIENTATION OF CLASS 2 and CLASS 3 HITCH ADAPTERS IS IDENTICAL