Husky HV02000 - Manual (Page 11)

Problem Cause Remedy
Vac will not pick up dirt 1. Clogged filter 1. Clean or replace filter
(follow instructions on
page 10)
2. Clogged hose 2. Remove hose and
clear debris.
3. Air leak 3. Make sure power
head is securely
attached to dust drum.
Vac will not run 1. No electricity 1. Make sure electrical
outlet has voltage.
(A qualified electrician
may need to be
contacted).
WARNING: If any of the power head assembly parts should become
detached or broken, exposing motor or any other electrical components,
operation should be discontinued immediately to avoid personal injury or
further damage to the vacuum. This vacuum has no user serviceable parts.
Cleaning
To keep your Wet/Dry Vac looking its
best, clean the outside with a cloth
dampened with warm water and mild
soap.
To clean the drum:
1. Dump debris out.
2. Wash drum thoroughly with warm water
and mild soap.
3. Wipe out with dry cloth.
Storage
Before storing your vac, the dust drum
should be emptied and cleaned. The cord
should be wrapped around the unit and
the hose should be stored as described
in the cord/hose storage section in this
manual. Accessories should be kept in
the same area as the vac so they can be
readily available. The vac should be
stored indoors.
Replacement filters are available where
you purchased your vac. The stock
number is VF2000.
Troubleshooting
Replacement Filter
11
SP6689-2 Husky HV0200_ES.qxd 4/18/08 3:48 PM Page 11