Holley COMMANDER 950 - Manual (Page 24)

24
9.
¨
SAVE PARAMETERS
It is recommended that you save your map to the computer hard drive anytime you make changes, that way you can
always go back to a previous version. At this time you should save that map that has the correct engine parameters.
To save the map perform the following:
A. Turn the ignition on.
B. Go to “File” and “Retrieve ECU Data”
C. Go to “File” and “Save Data to Disk”
D. Select the directory that you want to save it to
E. Type in a name for the map
F. Either hit “Enter” or click on “OK”
The map is now saved on the computer hard drive in the directory you selected. It may be opened and sent back to the
ECU if needed. The default directory is “CMDR 950”.
10.
¨
Next, we will verify that all of the sensors are working correctly. Select “Fuel” and “Main Fuel Map”. This brings up
the base fuel map. At the top is the Data Monitor, which among other items, shows all the outputs from the sensors.
Several of these will be verified before we start the engine. The ignition key needs to be ON to view the data. The
following picture shows typical key on values.
If any of these sensors are not reading correctly, see the troubleshooting area and correct the problem before
attempting to start the vehicle.
Figure 6 Data Monitor Showing “Key On” Values