Harbor Freight Tools Chicago 46237 - Manual (Page 11)

SKU 46237 For technical questions, please call 1-800-444-3353. Page 11
SpeciFicAtiOnS
Electrical
Requirements
120 V~ / 1300 W Input,
780 W Output
Motor No Load Speed 8,500 RPM
Wheel Diameter
7”
Arbor Diameter 7/8”
Spindle Thread 5/8” x 11 TPI
e194601
95gA
unpAcKing
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
inStructiOnS FOr
putting intO uSe
read the entire impOrtAnt
SAFetY inFOrmAtiOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
tO preVent
SeriOuS injurY
FrOm AccidentAl
OperAtiOn:
turn the power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Assembly
tO preVent
SeriOuS injurY:
do not operate this tool with
one hand only or without the
Auxiliary Handle properly
installed.
Attach the Side Handle (24) by
screwing it into the hole on the right,
left or top of the Reducer (19), de-
pending on your preference.
Functions
This hand-held tool may be used for
grinding operations.