Fitting the loop handle, Assembling and dismantling the two-piece shaft, Assembly – Husqvarna 327LDX User Manual
Page 10: Dismantling
ASSEMBLY
10 – English
Fitting the loop handle
•
Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
•
Slide the spacer into the slot in the loop handle. Fit the
nut, knob and screw. Do not overtighten.
•
Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.
Assembling and dismantling the
two-piece shaft
Assembly:
•
Loosen the coupling by turning the knob.
•
Align the tab of the attachment (A) with the arrow on
the coupling (B).
•
Push the attachment into the coupling until the
attachment snaps into place.
•
Before using the unit, tighten the knob securely.
Dismantling:
•
Loosen the coupling by turning the knob (at least 3
times).
•
Push and hold the button (C). While securely holding
the engine end, pull the attachment straight out of the
coupling.
A
B
C