Husqvarna 966553901 - Manual (Page 28)

OPERATION
28
Starting the Engine
1. Sit on the seat.
2. Raise the mower deck to the transport position by
setting the lift pedals fully forward.
3. Activate the parking brake.
4. Disengage the mower blades by pressing the
blade switch downwards.
8065-004
Press the control for disengaging the mower deck
8065-017
Set mower deck to the transport position
7. Push foot pedal fully forward for transport position.
Set pin at desired cutting height. (Height selection
pin is removed by rotating 180
O .) Make sure that
the pin is inserted fully through the both sides of
the height panels.
The following conditions must be fulfilled before the
engine can be started:
• The blade switch for engaging the mower blades
must be depressed.
• The parking brake must be on.
• Both steering controls must be in the locked
(outer) neutral position.
8065-016
Set deck to selected cutting height