Cooling system, Spark plug, Two-piece shaft – Husqvarna 1153286-26 User Manual

Page 20: Air filter, Cleaning the air filter, Maintenance

Advertising
background image

MAINTENANCE

20 – English

Cooling system

To keep the working temperature as low as possible the
machine is equipped with a cooling system.

The cooling system consists of:

1

Air intake on the starter.

2

Fins on the flywheel.

3

Cooling fins on the cylinder.

4

Cylinder cover (directs cold air over the cylinder).

Clean the cooling system with a brush once a week, more
often in demanding conditions. A dirty or blocked cooling
system results in the machine overheating which causes
damage to the piston and cylinder.

Spark plug

The spark plug condition is influenced by:

Incorrect carburettor adjustment.

A dirty air filter.

These factors cause deposits on the spark plug
electrodes, which may result in operating problems and
starting difficulties.

If the machine is low on power, difficult to start or runs
poorly at idle speed: always check the spark plug first
before taking any further action. If the spark plug is dirty,
clean it and check that the electrode gap is 0,6-0,7 mm.
The spark plug should be replaced after about a month in
operation or earlier if necessary.

CAUTION! Always use the recommended spark plug
type! Use of the wrong spark plug can damage the piston/
cylinder. Check that the spark plug is fitted with a
suppressor.

Two-piece shaft

The drive shaft end in the lower shaft should be lubricated
with grease every 30 hours. There is a risk that the drive
shaft ends (splined coupling) on models with two-piece
shafts will seize if they are not lubricated regularly.

Air filter

The air filter must be regularly cleaned to remove dust
and dirt in order to avoid:

Carburettor malfunctions

Starting problems

Loss of engine power

Unnecessary wear to engine parts.

Excessive fuel consumption.

Clean the filter every 25 hours, or more regularly if
conditions are exceptionally dusty.

Cleaning the air filter

Remove the air filter cover and take out the filter. Wash it
clean in warm, soapy water. Ensure that the filter is dry
before refitting it.

An air filter that has been in use for a long time cannot be
cleaned completely. The filter must therefore be replaced
with a new one at regular intervals. A damaged air filter
must always be replaced.

Advertising