Hoover S1223 - Manual (Page 14)

Carpet
adjustment
The cleaning of carpet and rugs
takes place at the nozzle.
It is necessary to raise and lower
the nozzle for various carpet pile
heights by sliding the nozzle
control knob to the correct setting.
For ease in sliding knob, the handle
should be in the upright position.
The nozzle will not move Into the
adjusted position until the
cleaner handle is lowered to the
operating position.
NOZZLE
maximum cleaning performance the following carpet height settings
are recommended.
BARE FLOOR
HIGH
Cleaners with two settings:
l
Lowest setting (A):
Highest setting (B):
for floors and all types of carpet.
if easier pushing is desired while maintaining
good cleaning performance.
Cleaners with Four settings:
l
Lowest setting (1): for bare floors and low pile, level loop, kitchen
type carpet.
l
Next (2): for other types of carpet.
Higher for very deep pile carpet where easier
effort is desired, while maintaining
good c eaning performance.
Note: If the cleaner is difficult to push, slide the knob to the next higher
setting.
13