Husqvarna 96045000504 - Manual (Page 20)

20
• Disengage belt tension rod (K) from locking bracket
(L).
• Install belt onto engine clutch pulley (M).
IMPORTANT: Check belt for proper routing in all mower
pulley grooves.
M
• Engage belt tension rod (K) on locking bracket (L).
CAUTION: Belt tension rod is spring
loaded. Have a tight grip on rod and
engage slowly.
• Raise attachment lift lever to highest position.
• If necessary, adjust gauge wheels before op er at ing
mower as shown in the Operation section of this
manual.
FIG. 26
A
K
S
L
M
F
E
H
C
D
B
SERVICE AND ADJUSTMENTS
• Insert other end of link (E) into hole in front mower bracket
(H) and secure with washer and retainer spring (J).
E
F
H
G
J
FIG. 25
FIG. 27
• ATTACH FRONT LINK (E) - Work from left side of trac-
tor. Insert rod end of link assembly through front hole
in tractor front suspension bracket (F) and secure with
retainer spring (G) through hole in link located behind
the bracket.