Philips HD7446 - Manual (Page 8)

Flushing the appliance
1 Open the lid (Fig. 3).
2 Fill the water tank with cold fresh water and put the jug in
place (Fig. 4).
Do not put a filter and ground coffee in the filter holder.
3 Press the on/off switch to switch on the appliance. (Fig. 5)
, The power-on light goes on (HD7448 only).
Let the appliance run until the water tank is empty.
4 Switch off the appliance when all the water is in the jug.
5 Let the appliance cool down for at least 3 minutes before you start
to brew coffee.
using the appliance
Brewing coffee
1 Open the lid (Fig. 3).
2 Fill the water tank with fresh cold water (Fig. 6).
- The graduations on the left are for large cups (120ml).
- The graduations on the right are for small cups (80ml).
3 Close the lid.
4 Place the jug on the hotplate.
Make sure you place the jug properly on the hotplate.
Note: If you do not place the jug properly on the hotplate, the drip
stop prevents the coffee from flowing into the jug and the filter. As a result,
the filter may overflow.
5 Open the filter holder (Fig. 7).
6 Take a paper filter (type 1x4 or no. 4) and fold the sealed edges to
prevent tearing and folding.
In some countries, this coffee maker comes with a permanent filter. In
that case, do not use paper filters.
EnglisH 8
4222.001.9933.4.indd 8 19-10-09 09:49