Hawking Technology HNAS1 User Manual
Page 19
If you are using the Network Storage Center for the first time, the Setup Wizard will provide you with a
simple and easy way to set up the device. The Setup Wizard will guide you through the connections of
the necessary cables as well as the settings for network configuration.
Note: In the Setup Wizard, as well as the Network Storage Center’s web user interface, you will frequently see
the term “Network HD”. It is interchangeable with the term “Network Storage Center” and both are used to
describe the HNAS1. Please note, however, that “Network HD” is different from the term “HD” or “hard drive”.
“HD” or “hard drive” is used to describe a basic 3.5” IDE hard drive, not the Network Storage Center.
Please follow the steps outlined below:
1: Activate The Utility Software
Place the utility CD (included with the HNAS1 package) into your CD-ROM drive and wait for the Auto-
run menu to appear on your screen. Then click on Quick Setup Wizard. If the utility does not activate
automatically, click the Start button in the lower left corner of your screen, select Run, type
D:\autorun.exe (where D is the letter of your CD-ROM drive) into the open window and click Enter.
Welcome Page
The figure shown above is the Welcome page for the Quick Setup Wizard. Follow the program, as
shown in the pages that follow, to complete the LED check, installation of basic cables, and network
configuration.
Click Next to continue.
19