HP P6000 - Manual (Page 72)

Table 2 HP P6000 Performance Data Collector valid object_type values (continued)
Information displayed by the command Value of object_type
Disk state changes state_disk
DRM group state changes state_drm
Array state changes state_array
NOTE: Start_time and end_time are in mm-dd-yyyy hh-mm-ss format.
The object_id is an optional parameter. If it is not specified, all the performance data/state
changes, that fall within the specified time window, for all the objects of the type specified by
object_type
are displayed.
Table 3 (page 72) shows how to specify the object_id value for different object types.
For object types not listed in Table 3 (page 72) , retrieval by object_id is not supported and the
command will show an error message if object_id is specified.
Table 3 HP P6000 Performance Data Collector object_id values
How to specify the object_id Object_type value
Virtual disk UUID or friendly name Vd
Physical disk WWN Pd
Disk group number Vdg
Disk group number Pdg
Host port (FP1/FP2/FP3/FP4) Hps
Last 8 characters of the Host's Port ID in the form XXXX-XXXX Hc
Host port (FP1/FP2/FP3/FP4) Drt
Virtual disk UUID or friendly name state_vdisk
Disk group ID state_diskgroup
Disk WWN state_disk
DRM group ID or friendly name state_drm
Array WWN or friendly name state_array
You can use the following HP P6000 Performance Data Collector CLI options with the above
command: -csv, -tsv, -nh, -KB, -us, -nfn, -fo, -ts2, -fnid, -fd, -cn.
You cannot use the following HP P6000 Performance Data Collector CLI options with the above
command: -sz, -fvd, -cont, -dur, -ts1, -nots, -od, -tlc
Configuring the HP P6000 Command View server
The command to configure HP P6000 Command View access credentials is:
evaperf cvconfig server_name port username
where:
•
server_name is the IP address or hostname of the system where HP P6000 Command View
is running
•
port is the HP P6000 Command View port (usually 2372). No defaults are assumed here;
you must specify the port number exactly.
•
username is the HP P6000 Command View user name (the specified user should be a member
of HP Storage Admins or HP Storage Users)
72 Monitoring array performance using HP P6000 Performance Data Collector