Hitachi HAS-K250 - Manual (Page 12)

12
HAS-K250
(L) × 3
(N) × 1
 Attach the bracket (B) to the LCD projector using four M4 × 8 (G) hexagon
head screws.
Tightening torque: 0.98 N•m (10 kgf•cm)
 Attach the arm (M) to the base bracket (O).
Insert the tab at the top of the arm (M) in the groove at the top of the base bracket (O). Then insert the U-groove
at the bottom of the arm (M) in the groove of the vertical adjusting nut in the base bracket.
 Use three M5 shoulder screws (L), three washers (P) and one M5 screw with
spring washer and flat washer (N) to secure.
Tightening torque: 0.98 N•m (10 kgf•cm)
(N)
(L) (P)
(P)
(P)
(G)
(B)
Note:
Be sure not to mix up
the screw types.
Note:
Make sure that the bracket
(B) is correctly oriented.
(L)
(L)
Projection
direction
Projection
direction
Projection
direction
Projection
direction
WARNING
■ Never use screws other than those designated.
Failure to heed this warning may cause the projector to fall or other hazard
resulting in damage or injury.
Place the tabs (rear of arm) in the grooves.
(O)
(M)
Note:
Insert the vertical adjusting
nut as shown in the fi gure. Note:
Route the cables through this hole before
attaching the arm (M) to the base bracket (O).
*#5-A'0)KPFF